← Back to blog
WattleAddr Property

Unmapped Is Not Clear: Why a Property Hazard Check Needs Three Answers

11 November 2026 · 5 min read

Ask a simple question, “is this house in a flood zone?”, and you might expect a yes or a no. A government hazard map can only give that answer where someone has drawn the map. Where nobody has, the honest answer is a third one: the land is not mapped.

The three answers

  • In a mapped hazard area: a published register places this land inside a mapped hazard area.
  • Not in one: a register covers this land and does not place it in a hazard area.
  • Unmapped: no register we read covers this land, so the report cannot say whether the hazard applies. The council may hold its own information.

Many checks fold the third answer into the second. A blank line next to “flood” looks like good news. It may only mean that nobody has published a flood map for that land.

How common is unmapped land?

More common than most people expect. When we counted New South Wales addresses against the flood planning maps in the NSW Planning Portal's layers in November 2026, 115 of 128 councils had fewer than one address in ten on land with any flood planning map at all. Only 9 councils had a map for the land under nine in ten addresses or more, and 4 more were between one and nine in ten.

Counted by us from the NSW Planning Portal's flood planning layers, © State of New South Wales (Department of Planning, Housing and Infrastructure), CC BY 4.0. The Department has not reviewed or endorsed this count.

It is not only a New South Wales issue. In Queensland, the statewide floodplain overlay stops roughly 27 km short of Rocklea, a Brisbane suburb that flooded in 2011 and again in 2022. A check that relied on that layer alone would have nothing to say about it.

You can see the pattern council by council on the WattleAddr Property hazard map, which shades each New South Wales, Victorian and Tasmanian council by the share of its addresses on land a hazard map shows.

What to do when a report says unmapped

Why we built it this way

A confident wrong answer is worse than no answer. Reporting unmapped land as unmapped tells the reader where the register stops and their own enquiries have to start. Every WattleAddr Property report names the registers it read and the date each was current, so the reader can go to the source. Our explainer on unmapped land goes further.

To see what the registers say for an address, run the free check at property.wattleaddr.com.au. It tells you which registers cover the address, and the price, before you pay anything.

← All articlesGet in touch